DreamLine DL-6194C-01 Guida di Installazione

QWALL – 5 & SlimLine Shower Base Kit ACRYLIC SHOWER WALL AND SHOWER BASE KIT INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the righ

Ver. 1, Rev. 1 9 9. Place the Side panel (01) on a flat piece of plywood or particle board. Use a sharp industrial knife and a T-square to score alon

Ver. 1, Rev. 1 10 10. Take exact measurements of the fixture on the wall: • from the 1” (one inch) line in the corner of the shower to the fixture:

Ver. 1, Rev. 1 11 12. Drill the holes for the fixtures in the Side panel (01) using the proper diameter saw bit or a handheld jig saw. See Fig. 15 f

Ver. 1, Rev. 1 12 Fig. 17 ATTENTION: 14. Apply the sealant to the entire surface of the reverse side of the Back panel

Ver. 1, Rev. 1 13 15. Attach the Back Panel (09) to the center of the back wall with the equal distance between two lines. See Fig. 19 for details.

Ver. 1, Rev. 1 14 17. Apply the sealant to the entire surface of the reverse side of the Side panel (01). Also, apply the sealant around the drilled h

Ver. 1, Rev. 1 15 19. Apply sealant to the entire surface of the reverse side of the other Side panel (01). See Fig. 21 for details. 20. Slide the

Ver. 1, Rev. 1 16 ATTENTION; Prior to the next step, please be sure the part of the wall for installation of the Decorative edge molding (03) is clea

Ver. 1, Rev. 1 17Glass Shelves Installation Instruction 24. Determine the desired height for the Glass shelves (05) and mark the locations on the wa

Ver. 1, Rev. 1 18 26. Mount the Shelf brackets (04) to the wall using the Countersunk screws ST4.2×30 (07). NOTE: the padded set screw of the Glass b

Ver. 1, Rev. 1 QWALL – 5.1 (1 Back Panel) SHOWER ACRYLIC WALL INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify o

Ver. 1, Rev. 1 19 Product maintenance To insure long lasting life for your acrylic back walls, wipe them off after each use with a soft cloth. To

SLIMLINE SHOWER BASE SHOWER BASE DIMENSIONS AND INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 2Preparation 1. Examine boxes and packages for shipping damage. Carefully remove Shower base from th

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 3SINGLE THRESHOLD SHOWER BASE Center Drain Configuration MODEL SPECIFICATION D (in) W (in)

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 4Left-Hand Drain Configuration MODEL SPECIFICAT

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 5Right-Hand Drain Configuration

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 6NEO SHOWER BASE MODEL SPECIFICATION W (in) A (in) B (in) C (in) DLT-2

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 7QUARTER ROUND SHOWER BASE MODEL SPECIFICATION W (in) C (

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 8DOUBLE THRESHOLD SHOWER BASE Corner Drain Configuration MODEL SPECIFICATION W (in) C

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 9Left-Hand Drain Configuration MODEL SPECIFICATION D (in) W (in) D1 (in) W1 (in)

Ver. 1, Rev. 1 2 Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of the needed parts are inc

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 10Right-Hand Drain Configuration MODEL SPECIFICATION D (in) W (in) D1 (in)

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 11Diagram of the Shower Base in a Cross Section Finished Wall Cement board S

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 12Shower Base Installation Preparation 1. Ensure that the floor and the studs are at right angle. Pr

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 132. Install the shower drain (NOT PROVIDED) according to the drain installation manual (supplied wit

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 14 4. Level the tray and place marks on the studs above the upper edge of the tile flange. See

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 15 6. After the bedding material has been poured and before it sets, place the shower base into the p

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 16 Fig. 9 Product maintenance To insure long lasting life

DREAMLINE™EXCLUSIVELIMITEDWARRANTYASOFMAY6,2013Thiswarrantyextendsonlytotheoriginalowner/end‐userforhouseholduseonlyandisnottr

TEL: 866-731-2244 FAX: 866-227-1533 WWW.BATHAUTHORITY.COM For more information on DreamLineTM Shower Bases ple

Ver. 1, Rev. 1 3Detailed Diagram of Acrylic Shower Wall Components 56784219334" - 38"30" - 34" Packing List 01 Side panel 2pc

Ver. 1, Rev. 1 4Preparation for Installation of Back Panel 1. Place a mark on the walls at a distance of 1” (one inch) from the corner and draw a p

Ver. 1, Rev. 1 5 3. The Back Panel (09) has 3-1/8” flange on both sides and has to be cut equally from both sides if necessary. See Fig. 3 for det

Ver. 1, Rev. 1 6 5. Mark the measurement “W” on the Back Panel (09) and draw straight lines from top to bottom. NOTE: The Back Panel has to be trim

Ver. 1, Rev. 1 7 Fig. 7 Preparation for Installation of Side Panels ATTENTION: See Fig. 8 for details.

Ver. 1, Rev. 1 8 7. Measure the side walls of the shower from the 1” (one inch) line in the corner (from Step. 1) to the distance where you want Sid